Alias Brow Gel Collection 03

Cleanse the brows before beginning any product application. Ensure they are free of any oils.

Pro Tip: This step is only required for coarse, unruly brows that don't set easily. Skip to Perming Solution if not applicable.

Using a cotton tip, apply a light layer of adhesive across the brow base. Then use a brow comb to set the hairs in place at the preferred angle they wish to be laminated. (Comb through straight away as adhesive will dry quickly).

Apply a perming solution sachet with a cotton tip or pad to both brows. (One sachet quantity suffices both eyebrows). Comb hairs up from the base using a Lamination Comb and set in the desired angle. Cut out a piece of Brow Wrap, place on top of the brows and leave covered.

Leave to process as per the below Timing Guide:

• Very Thin or Fine Brow Hairs: 5-7 minutes
• Medium or Normal Brow Hairs: 7-8 minutes
• Coarse or Stubborn Hairs: 8-9 minutes (no longer than 9 mins)

Peel off Brow Wrap slowly. Remove the perming solution using a cotton pad.

Apply a fixing solution sachet with a cotton tip to both brows. (One sachet quantity suffices both eyebrows). Apply the product in an upwards direction. Cut out a piece of Brow Wrap, place on top of the brows and leave covered. Leave to process as per Timing Guide in the previous step.

Peel off Brow Wrap slowly. Remove the fixing solution using a cotton pad.

Microwave the brow wax for 60-80 seconds. Heat until melted to a creamy consistency. Stir the wax thoroughly with a spatula to obtain an even texture (remove lumps). Dip the end of the spatula in the brow wax and spread a layer on the skin, underlining the base of the brow. Wax should be applied in the hair growth direction. Let wax strip cool for 20 seconds. Slightly lift up the outer edge of the strip (ear-end) and strip off quickly, pulling in the opposite direction of hair growth.

Follow all steps as listed in the Brow Tint Application Guide.

Pro Tip: Advise your clients that the lamination procedure completed prior will naturally make the eyebrows more receptive to the tint, speeding up the development process.

Apply Keratin Nourish cream to both brows. (One sachet quantity suffices both brows). Use a clean lamination comb to evenly brush the product through the brows. This will ensure maximum nourishment.

The brows can take 24-48 hours to develop and cure post-treatment, which is why it's important to keep the following precautions in mind:

• Keep brows dry for 24 hours.
• Do not apply makeup or undertake further eye treatments for 24 hours.
• Avoid swimming/sauna/exercise or any activity that may cause excess moisture as this could curl or frizz the brow hair.
• Do not allow prolonged exposure to direct sunlight or heat.
• Do not apply Retin-A, AHA, or exfoliant around the brow area for 24 hours on either side of the treatment.
• Self-tanning products should be avoided on the face for 24 hours prior to and 24 hours after treatment.
• If any stinging or swelling occurs, apply a cold compress to soothe and seek medical advice.

Advise your client that daily aftercare and styling of the brows is important in maintaining the freshly styled brows.

A few droplets of our nourishing Brow Gold Oil should be applied to the brows daily to keep them healthy, moisturised and strengthened. (Begin using after 24 hours of treatment). For maintenance, each morning your clients’ laminated brows will require styling by brushing & setting in place with Alias Brow Lamination Gel. The brow gel can be styled in 3 different ways.