Wax Warmer

Brow Code Wax is best used at 70° Celsius/158° Fahrenheit. We recommend using the Brow Code Wax Warmer. The wax should be a honey consistency. If you find the wax too stringy, this means the wax is not warm enough.

Clean and prepare the area to be waxed with the Brow Code Micellar.

Check the temperature of the wax before use with a patch test on the inside of the wrist. Once heated to the recommended temperature, pick up a small amount of wax on a wax spatula – rotating constantly to avoid dripping.

With a wooden spatula apply a thin, even layer working in the hair growth direction. Always support the skin by pulling tight as you apply and remove wax to avoid discomfort and skin peeling.

Apply wax to the brow in small sections, starting with the top end of the brow. NOTE: Starting here allows for better flow and grip as this is where the hair ends. Leave a thicker edge at the end of the strip of wax applied. After spreading the wax, move the stick back and forth to tie off any stringy wax.

 Allow the applied wax to cool (approx.10 seconds). Raise the edge of the strip of wax slightly then pull off sharply pulling against the hair growth direction.

After hair removal, apply after wax oil. Remove excess brow hairs with Brow Code Slanted or Pointed Tweezers if needed.

• Avoid extreme heat such as hot baths or showers, saunas and steam rooms for at least 24 hours.
• Avoid swimming and sunbathing (including sunbeds or any exposure to UV light) for at least 24 hours.
• Avoid exercise or anything that makes you sweat for at least 24 hours.
• Do not apply any perfumed products to the area for 24 hours.
• Wash your hands before scratching or touching the area or try to avoid touching the area all together.
• Avoid the use of make-up on the brow area for 24 hours.
• No self-tanning products in the area for 24 hours.